Magura CLARA Manual page 11

w w w . m a g u r a . c o m
s e r v i c e @ m a g u r a . d e
11
Hold the hose carefully so that it cannot snap away! Cut the hose squarely!
The sleeve nut can be re-used. The olive and the insert (only Clara) cannot be
re-used and must be replaced!
5. Slide on the sleeve nut and a new olive onto the hose. Push the hose with the
sleeve nut and the new olive fully into the brake lever and tighten the sleeve nut with an
8mm open-end wrench. Tightening torque: 4Nm/34 in.lbs.
6. Only Clara: Press manually a new insert into the hose until it is fully seated.
Clamp the hose into the groove of the mounting device as shown.
7. Only Clara: Or clamp the mounting device as shown into a vice and hammer the
insert carefully into the hose. If your frame is not equipped for routing hydraulic lines
you should now mount the hose fitting kit for your rear brake according to the instruc-
tions that are included in the kit.
8. Slide on the sleeve nut and a new olive onto the hose. Push the hose with the
sleeve nut and the new olive fully into the brake lever and tighten the sleeve nut with an
8mm open-end wrench. Tightening torque: 4Nm/34 in.lbs. Remove now the 2mm
allen key slided between brake lever and lever blade.
9. Always check for correct installation by pulling on the hose. Make sure
that the system has no leaks. Squeeze the lever blade, hold pressure and
check hose connections and the reservoir cover for eventual leaks.
Squeeze the lever blade several times (pump) to push the pads to their proper
position until the lever feel becomes very firm. If you cannot realize this, bleed
the brake (see page 15 onwards).