Table of Contents
Advertisement
2) USALS (DiSEqC 1.3)
(1) Satellite Position
It points out the position of saved satellite. Change satellite position number to maximize quality level if needed.
(2) Local Longitude
Please input Local Longitude by numeric keys and adjust E.W by using ◀ ▶ keys.
(3) Local latitude
Please input Local Latitude by numeric keys and adjust N.S by using ◀ ▶ keys.
(4) Reference position
This is the same as DiSEqC 1.2 Reference except "resynchronization" function inapplicable.
(5) Move
The satellite's position of (1) and the one calculated by value of (2) & (3) will be shown. Press OK key and it will
move.
(6) Store
Please select "Store" and the current position will be saved.
2.1.8 Satellite Scan
After all LNB setting is finished, adjust antenna direction toward satellite until signal quality level maximized. Then select
and confirm Satellite scan to start scan and saved.
# If you press SIG key on RCU, signal strength menu will be displayed in the screen with beep sound.
2.2 Satellite Scan
Scan all the listed transponders in a selected satellite.
(1)Press OK key and select wanted satellite by using ▼&▲keys.
(If you want to scan several satellites once, you can control ◀ ▶ keys.)
Then press OK key to execute scanning.
(2) Transponder will be consecutively scanned in all selected satellites.
2.3 Advanced & TP Scan
Scan a selected TP or new TP.
(1) Select a satellite
(2) Select a TP in TP list or type any new TP data if needed.
ⓒ 2007 by Panarex Electronics
20
Advertisement
Table of Contents
