Table of Contents
Advertisement
(3) To enter channel edit menu
(4) To execute factory setting
(5) To enter installation menu.
In case of forgotten password programmed call Pansat's dealer to get master factory password.
4.3 Language
Press EXIT key after you select your preferable language and audio language by using VOL
English, German, French, Spanish, Italian, Portuguese, Turkish, Arabic
4.4 AV Output Setting
4.4.1 TV Type
You can set the TV type (PAL, NTSC and AUTO) by pressing VOL
If the setting value is Auto, then TV is set automatically by source program.
So, the source program is PAL, TV set PAL source program is NTSC, TV set NTSC.
In case you selected PAL mode accidentally and the TV picture rolling up and down, press remote button as follows to
recover.
Power Off -> SAT -> SIG -> Power ON
4.4.2 Aspect ratio
You can set the TV aspect ratio (4:3 for normal TV & 16:9 for wide TV) by pressing VOL ◀▶ keys.
4.4.3 Closed caption
You can set the closed caption ON/OFF.
4.5 OSD setting
You can adjust the transparency level and Banner timeout by using
password on/off by using
◀▶
5. System Setup
5.1 Data Transfer (Receiver to Receiver)
1) Connect null modem RS232 Cable (Pin #2 & #3 twisted) between master and slave receiver.
2) Hook up the master receiver to the TV and select transfer mode.
3) Turn the slave receiver power off/on to start.
Warning!
Do not disturb data transfer by touching any remote button, RS232 cable, IF cable, RCA cable etc. during
ke
ys.
◀▶
◀▶
keys.
key
. And you can select installation menu
◀▶
ⓒ 2007 by Panarex Electronics
keys.
26
Advertisement
Table of Contents
