Table of Contents
Advertisement
1)
DiSEqC 1.2
(1) Current position
Select the position number by using
(2) Movement
Select East / West by using
(3) East Limit Set
Move the position to the most eastern position and press OK then East Limit is stored.
(4) West Limit Set
Move the position to the most western position and press OK then East Limit is stored.
(5) Limits Disable
Select Disable limits by using OK key
(6) Go to reference
Select go to reference by using OK key
2) USALS (DiSEqC 1.3)
(1) Satellite Position
It points out the position of saved satellite. You can change the position of the satellite by numeric keys.
(2) My Longitude
Please input Local Longitude by numeric keys
(3) My latitude
Please input Local Latitude by numeric keys
(4) Reference position
This is the same as DiSEqC 1.2 Reference
(5) Move
The satellite's position of (1) and the one calculated by value of (2) & (3) will be shown. Press OK key and it will
move.
(6) Store
Please select "Store" and the current position will be saved.
2.1.8 Satellite Scan
After all LNB setting is finished, adjust antenna direction toward satellite until signal quality level maximized. Then select
and confirm Satellite scan to start scan and saved.
# If you press SIG key on RCU, signal strength menu will be displayed in the screen.
2.2 Satellite scan
Scan all the transponder of selected satellites.
(1)Press OK key and Select wanted satellite by using ▼&▲keys.
(If you want to scan several satellites once, you can control ◀ ▶ keys.)
keys
(#0~#26:default define, #27~#49: user define)
◀ ▶
◀ ▶
keys and press OK to stop
15
Advertisement
Table of Contents
