Table of Contents
Advertisement
RadioPro IP Gateway
3.2 Connect the Gateway to the Radio
Note: Before continuing, ensure that the programming cable has been disconnected from the front mic
connector.
See Section
4.1 Appendix - Radio Interface Cables
Connect the IP Gateway to the Control Station voice radio using the following steps:
1.
Connect the DB-25 side of cable S2-617691 to the DB-25 connector on the rear of the NEXEDGE NX-800 radio.
2.
Connect the DE-9 male side of the cable to the DE-9 female connector on the rear of the IP Gateway.
3.
Ensure that jack screws on both connectors are tightened to hold connectors in place.
Connect the IP Gateway to the Data Revert Control Station radio using the following steps:
1.
Connect the DB-25 side of cable 89-10505 (DB25 Male to DE9 Female) to the DB-25 connector on the rear of the
NEXEDGE NX-800 radio.
2.
Connect the DE-9 female side of the cable to the DE-9 male connector on the rear of the IP Gateway.
3.
Ensure that jack screws on both connectors are tightened to hold connectors in place.
Note: If the IP Gateway has not yet been configured with appropriate IP parameters, do NOT connect the IP
Gateway to an IP network.
Installation and Configuration Guide NEXEDGE NX-57xx/58xx
on Page
23
21
for interface cable details.
Advertisement
Table of Contents
