Kenwood NEXEDGE NX-57 Series Installation Manual page 20

Table of Contents

RadioPro IP Gateway

Configure the GPS settings.

If using GPS, configure the desired behavior for the radio by expanding the

System 1

In the

GPS

correct channel to use in the

Ensure the GPS Base ID Type includes the Control Station radio.

i. If using GPS with NXDN, in the NXDN section, enter a value for

ii. If using GPS with FleetSync, in the FleetSync section, enter a value for

Note: This is the ID the subscriber will respond to, which will be the ID of the data revert control station

radio.

If the Base ID does not include the Control Station(s), data will not appear in RadioPro.

Installation and Configuration Guide NEXEDGE NX-57xx/58xx

folder under that, and then select

section enable

GPS Report on Data Zone-Channel

GPS Report Channel

GPS Base

ID.

Personal

Features.

with a check mark, and then select the

box.

Personal

folder, expand the

GPS Base ID Type

and

Base Fleet

Base

and

Table of Contents