Table of Contents
Advertisement
RadioPro IP Gateway
3.1.3 Configure Subscriber Radios
Use the FPU, (Kenwood's NEXEDGE 'Field Programming Utility' configuration software) to configure NEXEDGE
radio parameters using the following steps.
1.
Configure the subscriber radio as any other radio.
a.
Using a Kenwood programming cable, connect the NX-5200/5300 Control Station radio to a PC or
Notebook that has the correct Kenwood FPU version (KPG-D1N in this case).
b.
Open the KPG-D1N FPU.
c.
Ensure that the correct COM port is selected.
d.
From the
button as shown below.
Feature Selections
e.
Enable
and then click the
Installation and Configuration Guide NEXEDGE NX-57xx/58xx
Model
Product Information
tab, choose the
that this radio is licensed for with a check mark in the appropriate boxes,
OK
button.
Kenwood FPU
page, and then click the
15
Read Configuration
Advertisement
Table of Contents
