Culligan Aquasential Select Plus Series Owner's Manual page 17

Culligan ® Aquasential™ Select Plus™ 10" Filtr-Cleer Filter
Culligan knows the more informed you are about your water treatment systems, the more confident you will be about its performance� It's because
of this and more than seventy years of commitment to customer satisfaction that Culligan is providing this Performance Data Sheet to its customers�
NOTE!
Read this Performance Data Sheet and compare the capabilities of this unit with your actual water treatment needs.
It is recommended that before purchasing a water treatment unit, you have your water supply tested to determine
your actual water treatment needs.
Manufacturer: Culligan International Company
9399 W� Higgins Rd�, Suite 1100
Rosemont, IL 60018 USA
(847) 430-2800
www�culligan�com
Product: Culligan
Substance Reduction
This system has been tested according to NSF/ANSI Standard 42 for the reduction of the substances listed below� The
concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal
to the permissible limit for water leaving the system, as specified in NSF/ANSI Standard 42�
While testing was conducted under standard laboratory conditions, actual performance may vary�
Substance
Particulate, Class IV particles ≥ 15 to < 30 µm
Flow Rate:
Rated Pressure Drop:
Operating Conditions
Water Pressure Limits:
Canada:
Temperature Limits:
Electrical Characteristics: 24V/60Hz, 10W
The Culligan ® Aquasential™ Select Plus™ 10" Filtr-Cleer Filter has been
tested and certified by WQA against NSF/ANSI Standard 372 and
NSF/ANSI Standard 42 for the Class IV (≥ 15 µm to < 30 µm) particulate
reduction as verified and substantiated by test data�
Performance Indicator: If water flow decreases or a noticeable taste change occurs, a reconditioning cycle should be
initiated� If conditions do not improve, contact your local Culligan dealer� They can determine if your filter requires servicing�
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the
system�
Media Replacement Frequency: Replacement frequency will vary with water conditions�
Refer to your Owner's Guide and printed limited Warranties (P/N 01040677) for more specific product information� To
avoid contamination from improper handling and installation, your system should only be installed and serviced by your
Culligan Dealer� Performance will vary based on local water conditions� The substances reduced by this product are not
necessarily in your water�
Buyer Signature _________________________________ Date __________
Seller Signature _________________________________ Date __________
17
01040677 B 07/21
®
Aquasential™ Select Plus™ 10" Filtr-Cleer Filter
Influent Challenge pH
At least 1,000 particles/mL
5�9 gpm
5�9 gpm @ 5 psi
20 - 120 psi (140 - 860 kpa)
20 - 90 psi (140 - 620 kpa)
33 - 120° F (1 - 50° C)
Effluent pH Requirement
≥85%