Westfalia RBG 200 C Instruction Manual page 15

For your own safety, please read the safety notes before using the
unit.
Assembling and Setting up the Double Grinder
Before undertaking any work on the machine, pull the power plug.
Setting up the Double Grinder
Before start-up the visor and the spark deflector must be attached to both
grinding wheels. The work piece support must not be further away from the
Attaching the Grinder to the Work Bench or a Support
cross. Align the grinder in such a way that all four holes in the grinder overlap
with the slots in the support. Attach the grinder with the screws.
Replacing the Grinding Wheels
To replace the wheel, loosen the three Allen head screws on the outer side of
the hood and remove the outer part. Now loosen the main retaining nut of the
stone with a suitable open end or ring spanner. The treads on the left hand
side are left hand treats; the nut is loosened by turning clockwise. Be careful
Rigging
grinding wheel than 2mm. Check this distance
regularly while using the grinder because the
diameter of the wheel decreases over time during
use. The Visor is installed together with the spark
deflector. The spark deflector should be mounted
as close to the wheel as possible to be effective.
To attach the grinder use nuts and M6 screws
which are approximately 20 – 25 mm longer
than your work top is thick. Drill two holes 150
mm and 110 mm apart through the work top.
Use the screws to attach the grinder to your
work top. The tops of dedicated grinder supports
typically have four slotted holes which from a
10