Westfalia RBG 200 C Instruction Manual page 14

wheels for cracks and other damage before each use.
•
Grinding wheels, flanges, discs and other accessories must precisely fit
the shaft of the grinder. Tools which do not precisely fit the shaft vibrate and
may cause loss of control.
•
The permitted speed of the tool must be at least equal to the maximum
no load speed of the power tool. Accessories which rotate faster than
permitted may be destroyed.
•
Diameter and thickness of the grinding wheels must conform to the
requirements of your power tool. Wheels of the wrong size can not be shielded
or controlled.
•
Use only grinding wheels which conform to the technical data in this
manual and on the wheels.
•
Regularly confirm whether the spark deflector and the work piece
support are not further than 2mm away from the grinding wheel. If necessary,
readjust the spark deflector and the work piece support.
•
The grinding wheels will rotate for some time after the engine has been
turned off. Never try to stop the wheels by hand.
•
Wear suitable clothing when using the grinder. Synthetic materials may
be damaged by flying sparks. Tight clothing will not get caught in moving parts
easily.
•
It is advisable to bolt the grinder to a work bench. In the foot of the
grinder are two slots, with which the grinder can be mounted.
•
Keep other people out of the immediate working area. All persons in the
working area must wear personal protective equipment. Fragments of the work
piece or the grinding disc may fly off and leave the immediate working area
and cause injuries or damage.
•
Keep the power cable away from rotating parts.
•
Do not use this tool close to combustible materials. These materials may
be
Safety Notes
•
Wear personal protective equipment. Always wear
safety goggles to prevent your eyed when using the
double grinder.
•
Do not use damaged grinding wheels. Check the
ignited by
9
flying sparks.