3-Axis Gyro Use Introduction - Freewing SebArt F-104 STARFIGHTER User Manual

3-Axis Gyro use introduction

Use 4pcs screws to fix the gyro on the fix board on the front of
battery compartment. Make sure the gyro decal is forward to the
nose cone direction when install.
Screw
(PA2.3x8 4pcs)
Gyro
Fix board Fix board
Gyro connection diagram
1. Please install gyro correctly;
2. Connect the servo cable of elevator/rudder/aileron to the Gyro input port.
3. Use 3pcs connection wires to connect the gyro output port and correct channels of receiver
4. If your receiver has enough channels, you can use another connection wire to connect gyro and
receiver,use to set up the gyro switch.
Gyro use introduction,please refer to the 《Gyro user manual》。
5.
Receiver
Control board use introduction
Refer to the channel remark on control board，
insert the connection cables of battery compartment
on the control board(except the servo cables of
aileron/elevator/rudder,the three channels connect
to the gyro directly.)After connect,use screws to fix
the control board to avoid its loose.
F104 control board have two functions:
1. Control the normal work of LED light and cabin door
2. Reduce the cable quantity in battery compartment.
11
R
Gyro tested before ship, and set up the default sensitivity value.
You can do small adjustments according to the actual situation.
If you need to restore a sense of value to the factory default, please
refer to this photo.
。
AIL servo
A-Screw （PA3x8mm 4pcs）
B- Control board
C- Control board mount
.
；
ELE servo
A
B
C
EN
；
RUD servo
F-104S Starfighter
Item No.:FJ310