Normal Operation; Buttons And Controls; Turning Your Circulator On - PolyScience LX Immersion Circulator Operator's Manual

Nor mal Operation
But tons and Controls
Power
Run
Stop
Menu
Increase Value
Decrease Value

Turning Your Circulator ON

Press the
All characters/symbols on the LCD will momentarily light,
after which the actual and set point temperature (in °C) will be
displayed. The Circulator is now in the Standby mode.
10
button on the rear of the unit.
Turns the Circulator On, placing it in
Standby mode.
Starts operation.
Places Circulator in Standby mode.
Display is lit, but neither the pump
nor heater is operating.
Accesses the Temperature
Controller's set-up sub-menus. The
items in these sub-menus are used
to select the temperature unit, adjust
the set point and set the timer.
Increase the temperature set point
or timer setting.
Decrease temperature set point or
timer setting.
110-874