Steps
1. Align and place the hard-disk drive assembly in the slot on the palmrest assembly.
2. Tighten the four (M2X4.5) screws to secure the hard-disk drive assembly to the palmrest assembly.
3. Connect the hard-disk drive cable to the connector on the system board.
Next steps
1. Install the
base
cover.
2. Exit the
service mode
3. Install the
SIM card tray
4. Install the microSD-card.
5. Follow the procedure in
WLAN card
Removing the WLAN card
Prerequisites
1. Follow the procedure in
2. Remove the microSD-card.
3. Remove the
SIM card tray
4. Enter the
service
mode.
5. Remove the
base
cover.
About this task
The following image indicates the location of the WLAN card and provides a visual representation of the removal procedure.
for 4G LTE enabled systems.
after working inside your
before working inside your
for 4G LTE enabled systems.
computer.
computer.
Removing and installing components
35