Steps
Align and place the power button into the slot on the palmrest assembly.
Next steps
1. Install the
ethernet
port.
2. Install the
I/O
board.
3. Install the
base
cover.
4. Exit the
service mode
5. Install the
SIM card tray
6. Install the microSD-card.
7. Follow the procedure in
Removing the power button with fingerprint reader
Prerequisites
1. Follow the procedure in
2. Remove the microSD-card.
3. Remove the
SIM card tray
4. Enter the
service
mode.
5. Remove the
base
cover.
6. Remove the
I/O
board.
7. Remove the
ethernet
About this task
The following image indicates the location of the power button with fingerprint reader and provides a visual representation of
the removal procedure.
NOTE:
Steps
1. Peel the power button cable with adhesive backing from the palmrest assembly.
2. Lift the power button with fingerprint reader off the palmrest assembly.
68
Removing and installing components
for 4G LTE enabled systems.
after working inside your
before working inside your
for 4G LTE enabled systems.
port.
computer.
computer.