Edid Setting - Kindermann MultiSwitch 41 4K60 Mounting And Operating Instructions

6.3 EDID settings
The EDID (Extended Display Identifi cation Data) is typically used by the source device to match its video
resolution with the connected display. In some circumstances it is helpful to set the EDID to a fi xed value.
The MultiSwitch 41 4K60 supports an advanced EDID management including an extensive list of
predefi ned EDID settings, please check the table below for further details.
Use the 4-pin DIP switch
EDID
Switch in the
lower position
= „ON",
Swich in the upper
position
Stereo Audio
= „OFF"
Stereo Audio
Stereo Audio
High Definition Audio
Note:
• Stereo Audio: LPCM 2Ch
• High Defi nition Audio: LPCM 8Ch, AC-3 6Ch, DTS 5.1, Dolby Digital 5.1
• The four user-defi ned EDID can be customized by RS232 command,
please refer to chapter 8.4 EDID management for more details.
7
on the rear panel to set the EDID to a predefi ned value.
9
Switch status
0000
0001
0010
0011
0100
0101
0110
0111
1000
1001
1010
1011
1100
1101
1110
1111
Video
Pass through (Default)
1920x1080@60Hz RGB 4:4:4 8bit
1920x1080@60Hz RGB 4:4:4 8bit
1920x1080@60Hz RGB 4:4:4 12bit
1920x1080@60Hz RGB 4:4:4 12bit
3840x2160@60Hz RGB 4:2:0 12bit
3840x2160@60Hz RGB 4:2:0 12bit
3840x2160p@60Hz 4:4:4 HDR 12bit
3840x2160p@60Hz 4:4:4 HDR 12bit
1280x800@60Hz RGB 4:4:4 8bit
1920x1200@60Hz RGB 4:4:4 8bit
User-defi ned EDID 1.
User-defi ned EDID 2.
User-defi ned EDID 3.
User-defi ned EDID 4.
Enable RS232 EDID management.
Audio
Pass through (Default)
Stereo
High Defi nition
Stereo
High Defi nition
Stereo
High Defi nition
Stereo
High Defi nition
Stereo
Stereo
23