Flex ALC 514 Operating Instructions Manual page 17

Line laser
n
To switch off the laser lines, press the
appropriate button.
When the last laser line has been
switched off, the LED (4) goes out.
On completion of work:
n
Switch off the appliance.
Using the power tool with receiver
(Accessories)
The RC 2 receiver increases the range of the
laser and enhances use in unfavourable
lighting conditions.
17 Laser beam receive window
18 Laser position LED
19 On/Off button for receiver
20 Vertical spirit level
21 Acoustic signal button
Switches the acoustic signal on and off
22 Horizontal spirit level
23 Display
24 Zero line
44.5 mm from upper edge of housing
25 Loudspeaker
The receiver can be attached to a telescopic
or levelling rod, etc., with the optionally
available bracket.
n
Attach the receiver to the retaining
clamp with the knurled screw.
n
Attach the retaining clamp to the
telescopic or levelling rod with the
clamping screw.
n
Align the levelling rod horizontally or
vertically (as required) using the level
(20 or 22) installed in the receiver.
Working with the receiver:
Note
If using the receiver on the laser, press button
P (5). The brightness of the laser lines is
reduced.
n
Switch on the receiver with the On/Off
button (19).
n
Switch the signal on and off.
n
Hold the receiver in the rotating laser
beam.
One of the following displays is indicated
depending on the position of the laser
beam:
a) Receiver too high
b) Receiver at laser beam level
c) Receiver too low
Note
– Slowly move the receiver up and down.
Machine responds very sensitively.
– Also the position of the laser beam is
indicated by the LEDs (18).
17