Introduction; Range Description - Lennox eNeRGy Series Installation, Operating And Maintenance

INTRODUCTION

All the technical and technological information contained in this manual, including any drawing and technical
descriptions provided by us, remain the property of LENNOX and must not be used (except in operation of this product),
reproduced, issued to or made available to third parties without the prior written agreement of LENNOX.
General description
The eNerGy range is an air cooled rooftop packaged unit designed for comport air conditioning.

Range description

The present manual applies to the following units
E
Type of unit : eNeRGy
014
Range of airflow x 1000 m3/h
A
A : Air cooled
H
H : Heat pump units
055
Indicative capacity in kW
F
F : Scroll compressor
M
M : Refrigerant R410A
2
Version 2
M
M = 3 phases
Safety codes & regulations
The unit is designed for outdoor installation only. The unit must be installed in accordance with local safety codes and
regulations and can only be used in well ventilated area.
Inspections and requalification according pressure equipment directive must follow the local regulations where the unit is
installed. Commissioning, monitoring, periodic verification and requalification obligations may be made mandatory in some
countries. Please refer to it when installing the equipment.
You must read and be familiar with this operating manual prior to set up the equipment and commission the unit. Please closely follow
the instructions. We would like to stress the importance of training with respect to the correct handling of the unit.
Please consult LENNOX on the options available in this field.
It is important that this manual is stored in a permanent location in the vicinity of the unit
eNeRGy-IOM-2020.12-EN
• •
6