Table of Contents
Advertisement
To select the State Report
option
To change your SMART
Hub's display device
control script
14 |
I N S T A L L IN G Y O U R S M A RT B O A R D 6 85 IX P R E MI U M I N T E R A C T I V E
WH IT EBOARD SYS T E M ( A P P L I A NC E - B A S E D )
4. Insert the control module cable (see Installing the control module cable on
page 11) into connectors 2 and 3 on the bottom of the pen tray, and then press the
cable into the strain-relief channels.
Connector 3
5. Move all the pen tray cables out of sight behind the interactive whiteboard.
6. Place the four pens and the eraser into their respective slots in the pen tray.
Configuring the projector to turn on or off
You must select the State Report option in the projector's Service menu to allow the
projector to report its power state to the SMART Hub SE240 or SMART Hub VE220.
IMPORTANT
If you do not perform the following procedure, your UX60 projector doesn't turn on
or off when you press the control module's Power button on your SMART Board
interactive whiteboard's pen tray.
1. Press the button sequence Down-Up-Up-Left-Up on the projector's remote
control.
The projector's Service menu appears.
2. Select the State Report option.
IMPORTANT
Do not change any other settings.
3. Exit the Service menu.
Configuring the hub to control the projector
To allow the SMART Hub SE240 or SMART Hub VE220 to control your projector's
power state, you need to configure your hub's display device control script.
1. Select System > Settings.
The SMART Hub SE240 Settings or SMART Hub VE220 Settings dialog box
appears.
2. Select Display Configurations > Display device control script.
Control Module Cable
Connector 2
Advertisement
Table of Contents
