Advertisement
UNINET IMAGING INC. • OKIDATA C 7000 / 7100 REMANUFACTURING INSTRUCTIONS
12. Slide the end cap with axle out
completely.
15. Remove the developer roller as
shown.
18. Remove the wiper blade as shown.
www.u ni n e t
imaging.com
11124 Washington Blvd., Culver City, California U.S.A. 90232 Ph: 310 280-9620 • Fx: 310 838-7294 • sales@uninetimaging.com
© 2005 Uninet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. Uninet Imaging does not guarantee or warrant downloaded information.
13. Remove the screws on the remain-
ing end cap (gearside) that hold it in
place.
16. Remove the OPC drum as shown.
19. Pull out the fuse holder located on
the side of the cartridge.
USA
EUROPE
Ph:
+1-310-280-9620
+34-93-757-1335
Fx:
+1-310-838-7294
+34-93-741-4166
14. Remove the end cap with gears as
shown.
17. Remove the two screws on both
ends of the wiper blade that hold it in
place.
20. After cleaning and refilling the car-
tridge, replace the fuse and reassem-
ble the cartridge by following the steps
in reverse order.
JAPAN
BRAZIL
+81-3-44-55-2789
+55-11-4822-3033
+1-310-838-7294
+55-11-4822-3353
ARGENTINA
+54-11-4571-2388
+54-11-4574-3706
Advertisement
