Siemens DPU User Manual page 45

CHAPTER 4 |
DEVICE PROGRAMMING UNIT USER'S MANUAL
The LOOP field will display "1" for FS-100, FS-250 or FC2005
systems, since they are single loop systems. This field cannot be
changed.
3. Use the left and right buttons to move the cursor
over the various numerical fields to set the starting
address (S' A DD), the ending address (E' A DD), the
loop number (LOOP) and the number of copies
(COPIES) of the label—from 1 to 9—that you wish
to print.
4. When these have been set correctly press the
PRINT button. The DPU will then begin printing the
labels and the display will indicate that printing is in
progress.
5. An ABORT button is provided to allow the user to
cancel the printing operation and return to the bulk
printing display.
6. The display will indicate when the printing has been
completed.
7 . To return to the bulk printing screen to print another
batch of labels, use the EXIT button.
If the printer does not work, turn off the DPU, wait a few
seconds, and then turn it back on and try again.
PRINTING LABELS
41