Siemens DPU User Manual page 15

CHAPTER 2 |
BOTTOM OF DPU
*NOTE:
When programming or testing MXL
and FS-100 devices, the prong on
the same side of the programming
plug as the locating tab goes into
the black banana jack.
BOTTOM
OF DPU
*NOTE:
The prong on the same side
of the programming plug as the
locating tab goes into the black
banana jack.
DEVICE PROGRAMMING UNIT USER'S MANUAL
PROGRAMMING
PLUG
*
LOCATING TAB
To Program/Test HTRI-M/TRI-B6M Devices:
BLACK
BANANA
• Insert the programming plug in one end of cable
JACK
P/N 555-133891 into the red and black banana
jacks in the cable compartment in the bottom of
the DPU.
• Using the two alligator clip adaptors provided on
the programming plug, connect the other end of
cable P/N 555-133891 to the red and black wires
of the HTRI/TRI device.
To Program/Test A Compatible Series ILI/ILP
PROGRAMMING
Detector, connect the DPU to the DB-3S Base
PLUG
Adaptor:
*
LOCATING
• Insert programming plug of P/N 515-033925 into
TAB
the red and black banana jacks in the cable
compartment in the bottom of the DPU.
• Align notch in detector cover to raised surface
on outer ring of base.
• Push detector head into base and rotate
clockwise to make electrical connections. The
detector automatically stops and locks into
place.
To Remove Detector Head:
• Push detector head into the base while rotating
the detector head counterclockwise. Continue
to rotate counterclockwise until stop is
reached.
BLACK
BANANA
JACK
CABLE P/N 555-133891
WITH ALLIGATOR CLIPS
DPU DB-3S BASE
ADAPTOR
P/N 515-033925
PROGRAMMING
11