Siemens DPU User Manual page 29

CHAPTER 2 |
DEVICE PROGRAMMING UNIT USER'S MANUAL
• Connect the device programming cable to the device
to be programmed. (Refer to Figure 2, pages 10-11.)
When the DPU has detected the device, the display
will appear similar to the following:
FS-TRI-D AL/AL NO/NO
ADDRESS=41
<EXIT
The top line indicates the device type, the contact
state of the inputs and the device usages. The next
line shows the address that the device will be set to.
The FS-TRI-D requires two consecutive addresses.
• If the settings are correct, press PROGRAM to prog-
ram the FS-TRI. If label printing is selected, up to
nine labels will be printed. If the TRI is programmed
correctly, the display will appear similar to the
following:
FS-TRI-D AL/AL NO/NO
ADDRESS=41
PROGRAMMED OK
<EXIT
Press EXIT to return to the Main Menu. Use the
CHANGE button to go back and change a setting.
• If the FS-TRI was not programmed correctly, the
display will show;
FS-TRI-D AL/AL NO/NO
LOOP=1 ADDRESS=41
PROGRAMMING FAILED
<EXIT
Press EXIT to return to the Main Menu. Press RE-
DO to reprogram the device.
• If the FS-TRI was programmed correctly and the
device is removed, the "searching" screen will
display.
ADDRESS>
PROGRAM>
CHANGE>
RE-DO>
PROGRAMMING
25