Add/Remove Channels From Scan Memory; To Start Channel Scan - Uniden XTRAK 50 Series Owner's Manual

Operation

Add/Remove Channels from SCAN memory

1. Select which Scanning Mode you wish to use.
Press & hold the [OS/GS/MS] key to change OS or GS Mode.
O.S or G.S icon appears on the display.
2. Press [ ] or [
3. Press & hold [MEM] for 1.5 secs. to store.
MEM icon appears and a short tone beep is heard.
4. To remove the channels from Memory:
Press & hold [MEM] for 1.5 seconds once more.
Two short tone beeps are heard and the MEM icon disappears.

To Start Channel SCAN

1. Press [SCAN] and the radio will begin scanning the channels that are
in the OS or GS memory - depending on which of these is currently
active. SCAN icon flashes during scanning.
Scan Direction
SCAN will begin scanning for active channels in a sequential order.
You can change the scan direction (increasing or decreasing channel
number) by pressing [
Drop-out delay
When SCAN finds a busy channel it pauses scan to receive the
signal. When the received signal stops, the radio waits for 3 seconds
for the return of the signal, otherwise, the radio resumes scanning.
Recent Active Channels
SCAN remembers recent active channels and monitors these channels
for activity while scanning through the scan memory. This means if
recently active channels become active again during SCAN, the radio
will pause on these channels first. This makes scanning for active
channels more efficient (faster) the longer SCAN is operating.
UNIDEN XTRAK 50 Series
] to select the channel you want to store.
] or [ ].
22
Handheld UHF-CB Transceiver