Uniden XTRAK 50 Series Owner's Manual page 30

Operation | Special Features
Setting up Master Scan Mode
First, Setect a G.S Memory Preset to use as the Master Scan chan-
nel group.
P- No Change Master Scan with the current Group Scan (GS) memory.
P1: Master Scan with CH 09-20 loaded into GS memory.
P2: Master Scan with CH 21-30, 39, 40 loaded into GS memory.
P3: Master Scan with CH 49-60 loaded into GS memory.
P4: Master Scan with CH 61-70, 79, 80 in GS memory.
1. Press [MENU] and then press [
is highlighted.
2. Press [MENU] to select.
3. Press [ ] or [
4. Press and hold [MENU] to save & exit from the menu mode.
The Presets (1-4) make it easier for all radios to select a
common setting. If you choose to use MASTER SCAN with
the current GS channel memory (P- No Change), you need
to make sure all other radios in your network have the same
NOTE
channels stored in GS memory. To add/remove channels
from G.S SCAN Memory, refer to page 22.
RX only Channels (CH22, CH23, CH61, CH62 and CH63)
and Emergency Channels (CH05, CH35) will not be
included in Master Scan Mode even though stored into GS
Memory. Also channels for which Duplex Setting is On will
NOTE
be skipped in Master Scan Mode.
Second, Select a Master Scan subcode
1. Press [MENU] and then press [
highlighted.
2. Press [MENU] to select.
3. Press [ ] or [
4. Press and hold [MENU] to save & exit from the menu mode.
UNIDEN XTRAK 50 Series
] to change the setting to a Master Scan option.
] to select a CTCSS or DCS code.
] or [ ] until 08 GS Mem. Preset
] or [ ] until 09 M.Scan Code is
30
Handheld UHF-CB Transceiver