Operation
Add/Remove Channels from SCAN memory
1. Select which Scanning Mode you wish to use.
Press and hold the [OS/GS] key to change OS or GS Mode.
OS or GS icon appears on the display.
2. Rotate the [CHANNEL] knob or press [
channel you want to store.
3. Press and hold [MEM] for 1.5 secs. to store.
MEM icon appears and a short tone beep is heard.
4. To remove the channels from Memory:
Press and hold [MEM] for 1.5 seconds once more.
Two short tone beeps are heard and the MEM icon disappears.
To Start Channel SCAN
1. Press [SCAN] and the radio will begin scanning the channels that are
in the OS or GS memory - depending on which of these is currently
active. SCAN icon flashes during scanning.
Scan Direction
SCAN will begin scanning for active channels in a sequential order.
You can change the scan direction (increasing or decreasing channel
number) by rotating the [CHANNEL] knob or pressing [
Drop-out delay
When SCAN finds a busy channel it pauses scan to receive the
signal. When the received signal stops, the radio waits for 3 seconds
for the return of the signal, otherwise, the radio resumes scanning.
UNIDEN UH755
] or [
18
Handheld UHF-CB Transceiver
] to select the
] or [
].