Fire Sense 60368 Manual page 8

ASSEMBLY
9
While supporting heater, tilt the Head Assembly
and slide 3 Large Flat Washers over the
Place the
slide 3 Large Flat Washers over the
onto the
Once you have tightened the Wing Nuts, return the heater
to an upright position.
Hardware Used: 6x Large Flat Washer | 3x Wing Nut
10
Connect the hose and regulator to the LPG tank.
The LPG tank is sold separately. Use a standard
20 lb. propane tank only. Lift the Tank Housing
on the top of the assembled Post Supports
H onto Gas Hose E . Do not cross thread. Attach the Regulator
to the valve on the LPG tank and hand tighten securely. Place
LPG tank onto base of heater. Secure the LPG tank by attaching
the Chain L onto the post supports. Lower the Tank Housing.
NOTE: Use this heater only with a propane vapor withdrawal
supply system. See chapter 5 of the standard for storage and
Contact us for assistance: (866) 985-7877 | www.
C
onto the
and
. Secure with 3 Wing Nuts.
up and rest it
D
I . Screw Regulator
.
and
8