Fire Sense 60368 Manual page 11

OPERATING INSTRUCTIONS
LIGHTING
NOTE: For initial start or after any cylinder
change, hold the control knob in for 2
minutes to purge air from all gas lines
before proceeding.
1. Turn the control knob to the "OFF"
position.
2. Fully open the LPG tank valve.
3. Push in and turn the control knob
to HI symbols.
4. Keep the control knob depressed
and then push the RED igniter button
simultaneously, push several times to
ignite the main burner. Repeat until the
burner ignites. Keep the control knob
fully depressed for an additional 30
seconds after the burner ignites, then
release the control knob.
knob clockwise towards HI. To
knob counter-clockwise towards LO.
6. To turn the appliance OFF, depress the
control knob and turn clockwise to the
OFF position.
7. Wait at least 5 minutes before
attempting to re-light the heater.
8. Turn the LPG tank valve to OFF
or closed. If you experience any
ignition problems, please consult
"Troubleshooting"
smoke and odor from the burning of oils used in the manufacturing will
appear. Both smoke and odor will dissipate after approximately 30 minutes.
The heater should NOT produce thick black smoke.
Contact us for assistance: (866) 985-7877 | www.
.
FOR YOUR SAFETY
Be careful when attempting to manually
PUSH IN ignite this heater. Holding in the control
knob for more than 10 seconds before
upon ignition.
WHEN HEATER IS ON:
Emitter screen will become bright
red due to intense heat. The color is
more visible at night. Burner will
display tongues of blue and yellow
produce thick black smoke,
PUSH &
indicating an obstruction
HOLD
tops. If excessive
WHILE
"Troubleshooting"
PUSHING
IN BUTTON
RE-LIGHTING:
Note: For your safety, the control
knob cannot be turned OFF
control knob and then rotating
to OFF.
1. Turn control knob to OFF.
2. Wait at least 5 minutes to
allow gas to dissipate before
re-lighting.
3. Repeat the "Lighting" steps
listed above.
WARNING
yellow
and consult
11