Advertisement
Before handling the SIM card disconnect the router from the power supply!
3. Power
The router requires an external DC power supply. The DC voltage required is between
+10 to +60 V DC. The router has built-in protection against reverse polarity without signaling.
Connect the power supply cable to the PWR connector on the front panel of the router, see
the figure below.
4. Ethernet
For an initial configuration, made in a web browser, connect a PC by an Ethernet cable to
the default LAN interface, use the ETH0 port, see the figure above. By default, this interface
has the following configuration:
Connector
Purpose
ETH0
LAN port (default)
Connect your PC to this port to get the
router web interface.
QSG-0002-EN, August 4, 2021
Default Setting
DHCP Server
IP Address: 192.168.1.1
NetMask: 255.255.255.0
18
Released in the Czech Republic
SmartMotion
Advertisement
