BASICS
Initial Setup
Inside of Rain Sensor
Power Up
1.
Unlatch the Locking Tabs on the sides of the Rain Sensor to remove the Funnel.
Then install 2 "AA" batteries into the Battery Compartment.
2.
Install 3 "AA" batteries into the Battery Compartment of your Breeze Pro Sensor.
3.
Insert the Power Cord into a USB Power Adapter (not included), but sure the
adapter is securely plugged into a working outlet. Then insert the Power Jack
end into the back of the station. Remove the Insulation Tab from the station's
Battery Compartment.
Note:
It may take up to 10 minutes for your sensor data to appear on your
station's screen.
Bottom of Breeze Pro Sensor
Back of Station
Power Jack
02