Add-On Sensors - La Crosse Technology V50AU Setup Manual

EXTRA SENSORS
Additional Add-On Sensors
Whether you choose to connect with the La Crosse View
app or not, this station can display data for up to 4 extra
sensors. This data will appear in the blue EXTRA SENSOR
section on the LCD, and in your La Crosse View app if
connected.
Detect leaks & monitor ambient temperature
with an add-on Water Leak Sensor
Scan the QR code above or visit:
www.lacrossetechnology.com/ltv-wl1
Find all of your add-on sensor
options by scanning the QR
code or visiting:
Add-on Sensors are not included.
www.lacrossetechnology.com/v50au#parts
Adding Sensors to Your Station
1.
2.
Model Number
LTV-WL1
3.
4.
Water Leak Data Example
Hold the EXTRA button until you see the Sensor
Reception Indicator
Install batteries into your sensor. If the sensor
has a TX button, press it to force a transmission
signal. This button is usually located in or near
the sensor's battery compartment. The LED
light on the sensor will flash once.
Your sensor should connect within the next 3
minutes, briefly displaying its ID and type on
the LCD. The Sensor Reception Indicator will
show solid on the screen when a sensor is
connected.
Press the EXTRA button to cycle through the
data you'd like displayed on the LCD. The
Auto Scroll Icon ( ) will appear if activated.
Note: When first powering up, or after a factory
reset, extra sensors should automatically connect
to your station.
start to animate.
19