Table of Contents
Advertisement
DAP-300P
Configuring WAN Connection
This configuration step is available for the Router and WISP Repeater
modes.
You should configure your WAN connection in accordance with data
!
provided by your Internet service provider (ISP). Make sure that you
have obtained all necessary information prior to configuring your
connection. Otherwise contact your ISP.
On the Internet connection type page, from the Connection type
1.
list, select the connection type used by your ISP and fill in the fields
displayed on the
Static IPv4: Fill in the following fields: IP address, Subnet mask,
Gateway IP address, and DNS IP address.
Static IPv6: Fill in the following fields: IP address, Prefix, Gateway IP
address, and DNS IP address.
page.
Quick Installation Guide
30
Advertisement
Table of Contents
