Pc With Wi-Fi Adapter - D-Link DAP-300P Quick Installation Manual

Wireless n300 poe access point / router

Hide thumbs Also See for DAP-300P:

Table of Contents

DAP-300P

PC with Wi-Fi Adapter

1. For a switch supporting PoE: connect an Ethernet cable between the

PoE-enabled switch and the WAN port of the access point.

2. For a switch not supporting PoE or router: connect an Ethernet cable

between the switch or router and any Ethernet port of the access point.

3. Connect the power adapter (not included in the delivery package) to the

power connector port on the back panel of the access point, then plug the

power adapter into an electrical outlet or power strip.

4. Make sure that the Wi-Fi adapter of your PC is on. As a rule, modern

notebooks with built-in wireless NICs are equipped with a button or

switch that turns on/off the wireless adapter (refer to your PC documents).

If your PC is equipped with a pluggable wireless NIC, install the software

provided with your Wi-Fi adapter.

Now you should configure your Wi-Fi adapter.

Quick Installation Guide

Table of Contents