DAP-300P
Configuring Local Area Network
1. Go to the Connections Setup / LAN page.
2. If needed, change the IPv4 address of the access point's LAN interface
and the mask of the local subnet. To do this, click the IPv4 tab and
specify needed values in the IP address and Mask fields in the Local
IP Address section.
3.
If needed, change the static IPv6 address of the access point's LAN
interface. To do this, click the IPv6 tab and select the Static value from
the Mode of local IPv6 address assignment drop-down list in the
Local IPv6 Address section. Then specify the needed value in the
IPv6 address field.
Quick Installation Guide
39