Table of Contents
Advertisement
DIR-300S
Configuring WAN Connection
This configuration step is available for the Router and WISP Repeater
modes.
You should configure your WAN connection in accordance with data
!
provided by your Internet service provider (ISP). Make sure that you have
obtained all necessary information prior to configuring your connection.
Otherwise contact your ISP.
1. On the Internet connection type page, from the Connection type
list, select the connection type used by your ISP and fill in the fields
displayed on the page.
Static IPv4: Fill in the following fields: IP address, Netmask, Gateway IP
address, and DNS IP address.
Static IPv6: Fill in the following fields: IP address, Prefix and Gateway
IP address.
Quick Installation Guide
23
Advertisement
Table of Contents
