PCE Health and Fitness CTT Series User Manual page 8

To make settings for this measuring mode, press the "Menu" key twice.
Setting
Start Load
Initial Delay
Averaging Time
Average Mode
To select a parameter, use the arrow keys. Press the "Enter" key to select a parameter. Use the
arrow keys again to change the parameter properties. Press the "Enter" key again to apply the
settings you have made.
5.3.1 Measuring procedure
When "WAIT" is displayed on the screen, the meter waits until the set minimum load is applied.
When "DELAY" is shown on the display, the force gauge will wait until the set minimum time has
elapsed.
Meaning
Here you set the force at which the average measurement should start.
Here you enter the time span at the beginning of the measurement that is
not to be taken into account in the average measurement. Available
settings: 0.0 ... 300.0 seconds. Resolution 0.1 seconds. This parameter
only affects the MOD1 function.
Here you set the measuring time for the average measurement. Available
settings: 0.0 ... 300.0 seconds. Resolution 0.1 seconds. This parameter
only affects the MOD1 function.
Here you select between the MOD1 and MOD2 function.
© PCE Instruments
6