Electrolux EB6GL5QCN User Manual page 42

42 www.electrolux.com
12.10 Removing and installing
the door
You can remove the door to clean it.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A)
on the two door hinges.
3. Close the door until it is at an angle
of approximately 45°.
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
6. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, install
the door. Do the above steps in the
opposite sequence.
12.11 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
A
A
45°
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
The top lamp
1. Turn the lamp glass cover to remove
it.
2. Remove the metal ring and clean the
glass cover.
3. Replace the lamp with a halogen,
230 V, 40 W, 300 °C heat resistant
lamp.
4. Attach the metal ring to the glass
cover.
5. Install the glass cover.
The side lamp
1. Remove the left shelf support to get
access to the lamp.
2. Use a narrow, blunt object (e.g. a
teaspoon) to remove the glass cover.
3. Clean the glass cover.
4. Replace the lamp with a halogen,
230 V, 25 W, 300 °C heat resistant
lamp.
5. Install the glass cover.
6. Install the left shelf support.