Table of Contents
Advertisement
4.9 PE and Alarm
4.9.1
Paper End (PE)
The equipment detects if paper is still available.
BUSY (DTR) and PE, and turn on the PAPER lamp.
If the paper is set, the signals will be canceled and the PAPER lamp will be turned off.
cancellation, the equipment starts printing or waits for data entry.
still some data remaining in the buffer, printing will be resumed after setting new paper.
4.9.2
Alarms
If the auto-cutter is locked, the printing head is up, the printing head temperature is increasing, or there is
a certain failure, such as a paper jam, the equipment will halt printing, turn off the power for the motor
and printing head, and output BUSY (DTR), ERROR, and FAULT (Parallel only) to the host.
ERROR output can directly connect to an LED.
Error at power-on
The following faults are also possible, but a memory error has occurred.
contact your dealer.
When the auto-cutter is locked or the paper is jamming
Turn off the power and eliminate the fault.
because the power has been turned off.
reset, turn on the power again after eliminating the fault.
When the printing head is up
Shift the head up lever to the near side.
When the printing head temperature is increasing
If a large amount of data has been printed, such as in continuous printing, etc., the printing head
temperature will increase.
While printing is halted, various operations (paper feed, etc.) are not available.
printing head temperature to drop.
enabling printing.
CAUTION:
Never work with the printing head or motor immediately after printing, as they are hot and can burn you.
If such work is unavoidable, never touch them directly. Be fully careful of static electricity.
Do not eliminate the fault with the power left on.
The printing head is lowered, to enable printing.
If this is the case, printing will stop, to protect the printing head.
After a while the printing head temperature will drop,
If there are still some data remaining in the buffer, printing will be resumed.
27
If the paper has run out, it will stop printing, output
If the paper has run out, but there are
When this is done, the data in the buffer are erased
CBM-292/293 User's Manual
After signal
Turn off the power and
Wait for the
CITIZEN
To
Advertisement
Table of Contents
