Operation; Mounting Onto The Rack - Citizen CBM-292 User Manual

4. OPERATION

4.1 Mounting onto the Rack

(1) Fit the main body into the specified rack, etc., as shown in the figure below.
(2) Use the accessory fittings to catch the main body from the rear side, and secure it with the accessory
screws.
(3) After mounting, confirm that the front cover will open and close properly.
(4) Tighten the screws to such an extent that the fittings and main body case will not be deformed. Excessive
tightening not only imparts stress to the main body, it can also cause problems.
(5) The mounting rack should be as thick as 1 to 3 mm.
Precautions for Installation
• This printer does not support natural falling
of paper with full cut by auto cutter.
• Obstruction such as door, etc. shall not be
located in front of the front cover.
Otherwise, paper ejection is obstructed
resulting in paper jam or the like.
CAUTION:
Mount the equipment to the rack angled from 0° to 90°.
The screws for the mounting braket should be within 15 mm long.
22
CBM-292/293 User's Manual
CITIZEN