Table of Contents
Advertisement
4.7 Remedies for Paper Jam and Cutter Lock
If the paper jams or the auto cutter is locked, follow the procedure below to eliminate the cause.
safety, be sure to turn off the power prior to starting the work.
(1) Open the front cover.
(2) Press the mechanical lock lever inward, to lower the mechanism.
(3) Eliminating a paper jam.
paper from the printer mechanism, move up the printing head and pull it out gently.
(4) Unlocking the cutter.
unlocking operation will be completed if the cutter blade returns and the initial operation is performed.
If the cutter blade does not return or an error recurs, turn off the power, and turn the left inner knob of the
cutter toward the far side, as shown in the figure below.
caught paper gently.
(5) After eliminating the cause, raise the mechanism back to its home position, return the head up lever, and
turn on the power again.
CAUTION :
Never work with the printing head or motor immediately after printing, as they are hot and can burn you.
If such work is unavoidable, never touch them directly.
Be careful to avoid injury by the metal edges.
4.8 Self-Printing Function
The characters used, ROM version, and DIP switch information are printed by turning on the power with the
FEED switch held down or inputting a RESET signal.
printing.
Eliminate all the jamming paper carefully and gently.
Eliminate the paper from the cutter section, and turn on the power.
Then, turn on the power and confirm that the initial operation is performed.
Since the cutter blade withdraws, eliminate the
If the auto-cutter is attached, the paper will be cut after
26
CBM-292/293 User's Manual
For your
When pulling out the
Cutter
CITIZEN
Advertisement
Table of Contents
