Table of Contents
Advertisement
6.2 Precautions
(1) For the ERROR LED output, 330 is included in the circuit of the main body so that a current value will
be approximately 10mA. Use the LED whose forward voltage is approximately 2V. If the current value
exceeds 10mA in operation, the control board of the main body may go out of order or be broken.
(2) Connect all grounding conductors.
(3) The serial interface is equipped with a RS-232C driver and receiver.
level.
(4) The RESET pin is pulled up at 3.3k . Do not connect it if not used.
(5) Either serial or parallel interface is available.
(6) The accessory cable is approx. 300mm. Adjust the length as required. However, excessively extended
wiring may cause malfunctioning due to an effect of noise, etc.
(7) Only the pins for the serial interface should be connected to the 5V or higher power source.
the control board of the main body may be broken.
6.3 Power Connector Specifications
This is a power supply connector from the AC adapter attached to the main body.
Connector's Pin Configurations
No.
1
2
3
SHELL
Connector used
Applicable connector
Function
+24V
GND
N.C
FG
: TSC7960-53-2010(Made by HOSHIDEN) or its equivalent
: TSC8927-63-1100(Made by HOSHIDEN) or its equivalent
TSC8927-53-1100(Made by HOSHIDEN) or its equivalent
If not necessary, do not connect it.
31
CBM-292/293 User's Manual
Be sure to use at the RS-232C
Otherwise,
CITIZEN
Advertisement
Table of Contents
