Raider RD-OMT01 User Manual page 15

1. Remove the blade screw (1) and washer (2) from the accessory holder (3) by turning the
screw counter clockwise. Use the 5 mm Hex key (4) if the screw is too tight to be removed by
hand (Fig. 1).
NOTES:
a) For "open back" accessories (Fig. 1a), the blade screw does not have to be removed.
Simply loosen the blade screw sufficiently to allow the accessory mount to slide between the
washer and the accessory holder.
b) For "closed back" accessories (Fig. 1b), the blade screw and washer must be completely
removed from the tool.
NOTES:
a) Check to make sure the convex curve of the washer (9) is facing the head of the screw
and the slots in the edge of the washer fit over the alignment pins in the accessory holder.
b) Make sure the alignment slots in the blade are still mated with the alignment pins in the
accessory holder.
5. Firmly tighten the screw with the 5 mm hex key.
NOTE: Check to make sure the slots in the blade are still mated with the alignment pins on
the accessory holder after the screw is fully tightened.
INSTALLING SANDPAPER
1. Install the hook & loop sanding pad (1) onto the tool (Fig. 3).
2. Firmly press the sandpaper (2) onto the hook & loop pad.
NOTES: a) Place the sandpaper so the holes in the sandpaper line up with the matching
2. Place the blade (5) on the accessory holder
(Fig. 2).
NOTES:
a) Make sure the alignment slots (6) in the blade
fit over the alignment pins (7) in the accessory
holder and the printed side of the blade is facing
the tool.
b) The blade can be mounted at various angles
left or right of center if required.
3. Thread the screw (1) through the washer
(2) and the blade and into the accessory holder
threaded hole (8).
4. Turn the screw clockwise until it is finger
tight.
15