Set Averaging - GE HumiLab Operator's Manual

Set averaging

Appendix B — Humilab chilled mirror hygrometer details
The default is fix. You can select
are done, press E to exit.
Press 2 from the Display Switch sub-menu to determine the
behavior of the DISPLAY
and scaling information. The current status will be echoed,
followed by a sub-menu:
STATUS = VIEW ONLY
ENABLE/DISABLE SWITCH FUNCTIONS
1) VIEW ONLY
Press 1 to have the information viewable but not changeable (the
default). Press 2 so that it is viewable and changeable from the front
panel. Press 3 to hide the information at the front panel. In this last
case, the units and scaling are still in effect — they're just not acces-
sible using the DISPLAY
Press 3 from the Display Switch sub-menu to determine the
behavior of the DISPLAY
scaling. The following sub-menu will appear:
STATUS = VIEW ONLY
ENABLE/DISABLE SWITCH FUNCTIONS
1) VIEW ONLY
Make a selection in the same manner described above. When you
are done, press E to exit. Press
From the Main menu, press
averaging parameter. This figure (1 - 20) determines how many of
the most recent dew point readings are averaged to determine the
reading displayed and output. The factory default is 20. The
current value is echoed followed by a sub-menu:
NUMBER OF POINTS =20
1) SET AVERAGE
Press 1 to change the value. You will be prompted for a new value:
VALUE =
Type a value between 1 and 20 and press
be echoed. When you are done, press
Please consult the factory before attempting to calibrate the ana-
log outputs of the Electronics Module. All analog outputs are fac-
2 for alternate display. When you
switch with regard to the output(s) units
2) VIEW & CHANGE
switch. When you are done, press
switch with regard to alarm units and
2) VIEW & CHANGE
E twice to exit to the main menu.
5 to set the Electronics Modules data
E) EXIT
E
3) HIDE E) EXIT
3) HIDE E) EXIT
RETURN . The value will
to exit.
E to exit.
57
Page