The Main Menu; Scale Outputs - GE HumiLab Operator's Manual

The Main Menu

Scale outputs

Appendix B — Humilab chilled mirror hygrometer details
the main menu, press
able when BALANCE
active, the Electronics Module deactivates the sensor cooler control
circuit and allows the sensor mirror to rise to ambient temperature.
The front panel display of the Humilab will also blank. Press
the main menu to return to Operate mode.
1) SCALE OUTPUTS
4) DISPLAY OPTION
7) CALIBRATE OUTPUT2 8) SET ALARM
A) MOLECULAR WEIGHT
From the main menu, press
outputs. The current state of the output(s) is echoed, followed by a
sub-menu:.
OUTPUT1:
DP C:
HIGH =60
OUTPUT2:
TMPC:
HIGH=60
1) OUTPUT1
Press 1 to access Output1, the Humidity output. One of the
following menus will appear:
OUTPUT1:
0) DPC
Make a parameter selection, or press
If you make a parameter selection, the following then appears:
HIGH =
Enter a value and press
LOW =
Enter a value and press
and you will be returned to the Scale Outputs sub-menu.
You can now press
difference is the parameters which are available:
ESC twice. Note that the menu is not avail-
mode is active. Also, when menu functions are
2) SET BALANCE TYPE 3) SET RS232 UNITS
5) SET AVERAGING
E) EXIT
1 to assign and scale the analog
LOW = -40
LOW=-40
2) OUTPUT2
1) DPF 2) RH
RETURN . The following appears:
RETURN . The values entered will be echoed
2 to set Output2 in the same manner. The only
6) CALIBRATE OUTPUT1
9) SET INPUT 2 PARM
E) EXIT
E) EXIT
E to exit.
E from
53
Page