Table of Contents
Advertisement
Set RS-232
units
Appendix B — Humilab chilled mirror hygrometer details
Operate mode at the completion of the balance cycle. Alternatively,
press
E
to return to the main menu.
From the main menu press
output. The units selected for output and the handshake status will
be echoed followed by a sub-menu:
SELECTED UNITS = 1,2
HANDSHAKE = DISABLED
1) DATA
2) HANDSHAKE (TOGGLE)
Press
1
to set the RS-232C data display. The following sub-menu
will appear:
1) SELECT UNITS
Press
1
to select the parameters to be displayed. One of the
following sub-menus will appear:
1) DPC
2) DPF
5) TMPF
6) NONE
Press numbers individually to add the associated parameter to the
RS-232C data output. Press
data output or to clear before adding parameters. Press
are done.
At the Data sub-menu, press
user. The following will appear:
STATUS = DISABLED
ALLOW USER TO PROMPT FOR DATA
1) ENABLE
Press
1
to Enable User Prompt For Data. Now press
until you are back to the main menu. Press
mode. There will not be any data output. Press the following key
sequences followed by
with the key sequence:
D1 (DPC)
D2 (RH)
D3 (TMPC)
Please note that the "D" must be uppercase
3
to customize your RS-232C data
2) USER PROMPT
3) RH
E) EXIT
3
(or
6
or
2
to output data at the prompt of the
2) DISABLE
E) EXIT
RETURN
to see the parameter associated
3) EXIT
E) EXIT
4)TMPC
8
, depending on Model) for no
E
repeatedly
E
to enter Operate
E
when you
55
Page
Advertisement
Table of Contents
Troubleshooting
