Table of Contents
Advertisement
Display option
56
Page
In order to resume normal data output, press
the main menu, return to Set RS-232 Units and Disable User
Prompt For Data.
From the Set RS-232 Units sub-menu, press
shake protocol. The default is no handshake. You will be asked for
a password:
ENTER ACCESS CODE:
Type "ACCESS" and press
Press
E
to return to the main menu.
From the main menu press
panel
DISPLAY
switch. The default behavior is that all units are
available, the output(s) are viewable but not changeable.
One of the following sub-menus will appear:
1)DISPLAY UNITS
Press
1
to determine the behavior of the
regard to parameters. The following sub-menu will appear:
SELECTED UNITS =
1) SELECT
Press
1
to select the parameters shown by the
of the following sub-menus will appear:
1)DPC
2)DPF
5)TMPF
6)NONE
Press numbers individually to add the associated parameter to the
DISPLAY
switch sequence. Press
ters. Press
E
twice when you are done. This feature is not recom-
mended for closed-loop operation.
Press
2
to choose fix/alternate display. The following sub-menu will
appear:
1) FIX
2) ALTERNATE
In the fix display mode, the display will show only the selected unit
during normal operation. In the alternate display mode, the display
will alternate between available units at a 2-second interval. This
setting is not recommended for closed-loop operation.
RETURN
. The new status will be echoed.
4
to change the behavior of the front
2)OUTPUTS
3)ALARM
2) FIX/ALTERNATE DISPLAY
3)RH
E)EXIT
6
to clear before adding parame-
Appendix B — Humilab chilled mirror hygrometer
ESC
twice to return to
2
to change the hand-
E)EXIT
DISPLAY
switch with
E) EXIT
DISPLAY
4)TMPC
switch. One
Advertisement
Table of Contents
Troubleshooting
