Rs-232C Re-Programming Mode - GE HumiLab Operator's Manual

RS-232c re-programming mode

52
Page
• From Operate mode, press and hold
the CONTROL STATUS
annunciator will show "Humidity. "
Press S to View and/or Change the humidity output. The
CONTROL STATUS
humidity output units.
The CONTROL STATUS
of the main display will show the units available for the out-
put you are changing. Press and hold
units, and press
The CONTROL STATUS
rent high value will now appear on the main display. Press
to change this value. The right-most digit will blink.
Press N and hold to scroll through the digits and press
select one. The second digit from the right will blink.
Continue as before. Finally the sign for the value will blink.
The choices here are –, –1, 1, or "blank. " Note that the 1 is a
half-digit and that + is not shown.
Once the sign is set, press
changing sequence.
• You will now be given the opportunity to view and/or change
the low humidity output value. Note that you cannot change
the output units by accessing the low output value. This can
be done only by accessing the high output, as described
above. If you want to change the low output value, press
and proceed as above.
• You will then have an opportunity to view and/or change the
Temperature. Proceed as above.
See Appendix C for information on establishing RS-232 communi-
cations. Once you have established communications, follow the
menu descriptions here.
RS-232C re-programming is done via a series of menus and oper-
ates on firmware in the Humilab chilled mirror system. To access
display. In addition, the parameter
display will show "
display will show "
S to select one.
display will now show "
S
to continue through the output
Appendix B — Humilab chilled mirror hygrometer
N until " O " is displayed in
H . " Press S to change the
O . " The units portion
N to scroll through the
H ," and the cur-
S
S to
S