Table of Contents
Advertisement
EN
1.3. Safety instructions
DANGER
Escaping compressed gas
Risk of serious or even fatal injury from contact with escaping compressed gas or from unsecured plant
components.
•
•
•
•
•
DANGER
Mains voltage
Risk of serious or even fatal injury from electric shock when coming into contact with non-insulated,
powered components.
•
•
•
•
•
•
WARNING
Operation of device outside limit range
If the specified limits are exceeded, there is a risk of device malfunction, potentially resulting in injury
and/or damage to property.
•
•
•
•
•
•
Specialist technical personnel
1
Specialist technical personnel are persons who, due to their professional qualification and knowledge in the field of measuring,
control and pneumatic technology, and their knowledge of the applicable statutory regulations, guidelines and standards are in a
position to foresee potential dangers in relation to the use of the device and are qualified to perform the tasks described in this
manual. Special operating conditions (e.g. aggressive media) require additional knowledge.
5
Before carrying out any assembly, installation or maintenance work, depressurise the system. All
above work must be carried out by authorised specialist technical personnel
Use only pressure-resistant installation materials and suitable tools that are in proper working order.
Before pressurising the system, check all unit parts and repair them, if necessary. Open valves slowly
to prevent pressure blows during operation.
Make sure that no persons can be injured or objects can be damaged by condensate or escaping
compressed gas.
Protect the device parts against vibration and impact.
For the electrical installation of the device, adhere to all applicable regulations (e.g. VDE 0100 / IEC
60364).
Before carrying out any maintenance work, de-energize the system.
All electrical work must be carried out by authorised specialist technical personnel
The permissible operating voltage is printed on the type plate and must be strictly adhered to.
All components of the electrical installation on site must be approved and/or bear the CE mark.
A reliably accessible circuit breaker (e.g. power plug or switch) that shuts off all conductors must be
installed close to the unit.
The device must only be operated for the intended purpose and within the permissible limits
specified on the type plate and in the technical data.
From 10 bar, install a high-pressure protection element for safe installation and removal of the device.
Do not operate the device in connection with flammable gases.
Strictly adhere to the prescribed operating times and maintenance intervals.
Observe the prescribed storage and transport conditions.
Prevent condensation on the sensor element. Ensure that the air fed through the device is free of
droplets.
Installation and operating manual
.
1
.
1
METPOINT
SF13
®
Advertisement
Table of Contents
