Table of Contents
Advertisement
EN
Setup → 4 - 20 mA → Error Current
6.9. Info
Setup → Info
6.10. MBus
6.10.1. Default communication settings
Primary address*:
ID:
Baud rate*:
Medium*:
6.10.2. Transferred values
Value 1 with [Unit]*:
Value 2 with [Unit]*:
Value 3 with [Unit]*:
Value 4 with [Unit]*:
* these values can be factory-set or changed on request.
35
1
Serial number of sensor
2400
Gas
Flow [m³/h]
Consumption [m³]
Velocity [m/s]
Gas temperature [°C]
On this screen, you can enter the error signal to be sent by the
current output in the event of a fault.
•
2 mA = sensor fault / system error
•
22 mA = sensor fault / system error
•
None = output according to Namur (3.8 mA ... 20.5 mA)
< 4 mA to 3.8 mA = value below measuring range
> 20 mA to 20.5 mA = value above measuring range
Confirm your entry by pressing the >>ENTER<< button.
This screen shows device information.
Press "Details" to view the calibration conditions.
Installation and operating manual
METPOINT
SF13
®
Advertisement
Table of Contents
