Matrix COSEC ATOM RD100 Quick Installation Manual page 10

Disposal of Product after End-Of-Life
WEEE Directive 2002/96/EC
The product refered is covered by the waste Electrical and
Electronic Equipment (WEEE) directive and must be disposed
of in a responsible manner.
At the end of product life cycle; batteries, soldered boards,
metal components and plastic components must be disposed
through recyclers.
If you are unable to dispose-off the products or unable to
locate e-waste recyclers, you may return the products to
Matrix Return Material Authorization (RMA) department.
MATRIX COMSEC
Head Office
394-GIDC, Makarpura, Vadodara - 390010, India
Ph: (+91)1800-258-7747
Email: Support@MatrixComSec.com
www.matrixaccesscontrol.com
19
FCC Caution:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE:
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
20