VuLink works with Aqua TROLL, Level TROLL, Baro TROLL, and Rugged TROLL instruments.
Follow the steps below to start transmitting data.
5
Remove the battery pull-tab and press the button.
Make sure the antenna is
properly attached before
proceeding.
Never mix old and new batteries, or Lithium and alkaline batteries. Make sure all three batteries
are installed in the same orientation.
If VuLink has trouble connecting to a 4G network, switching to 2G may help. Launch VuSitu and
follow the instructions below. Contact your cellular provider for coverage details.
Press the All Settings
button at the bottom of
the screen.
1-970-498-1500
Setting Up Vulink
Remove the battery
cover by twisting it
counter-clockwise and
pulling down.
Troubleshooting Network Connectivity
Tap Cellular Network on
the Settings screen.
Remove the yellow pull
tab to allow current
to flow through the
batteries. Replace the
cover.
Tap 2G to change
VuLink's network
settings. Press Save.
7
Press the button. All
LEDs turn on. Then
each LED changes color
according to device
status.
VuLink should now be
able to connect to a
network and sync with
HydroVu.
www.in-situ.com